Hi Folks - I am a newbie and would greatly appreciate your input. Yesterday I cooked a 7 lb pork butt on my Traeger at 225 and after 4 hours the IT was already 165. (I live in Houston and the outside temp was around 95 and very humid.) Checked the IT with both the Maverick and Thermapen and they were both about the same. Everything I had read said to take it off when it got to around 195 and I actually took it off at 200. Problem was that it had only been cooking (at 225) for about 7.5 hours. I foiled it for about an hour until the temp dropped to around 170 and then pulled it -- sort of. It was tough-tough; I only pulled about half of it. (Then my wife took the rest and put in the crock pot, but then that's another whole story.)
Should I have turned the Traeger thermostat down to 180 and cooked it longer, instead of leaving it at 225 until it reached about 200? Not sure if time or temp is more important with a pork butt. I'm thinking now it would have been time. I cooked another butt a month ago and had no problems; only difference is that meat was rounder and a bit thicker than this one.
Over the past 6 weeks I've had good success with 2 briskets, 2 bb ribs, chicken, and a few other odds and ends - so at least that's encouraging.
Will greatly appreciate your suggestions so that if and when I do the next pork butt, it will be yummy.
Thanks so much for your help. Bill
Should I have turned the Traeger thermostat down to 180 and cooked it longer, instead of leaving it at 225 until it reached about 200? Not sure if time or temp is more important with a pork butt. I'm thinking now it would have been time. I cooked another butt a month ago and had no problems; only difference is that meat was rounder and a bit thicker than this one.
Over the past 6 weeks I've had good success with 2 briskets, 2 bb ribs, chicken, and a few other odds and ends - so at least that's encouraging.
Will greatly appreciate your suggestions so that if and when I do the next pork butt, it will be yummy.
Thanks so much for your help. Bill